Complex Efficiency of Using Wood Pellets in Power Plants

Complete text of the article:

Download article (pdf, 1.5MB )

UDС

662.6/9

DOI:

10.37482/0536-1036-2021-1-159-172

Abstract

In advanced countries, the dramatic impact of greenhouse gases on the global climate is reduced by replacing fossil fuels with biofuels. This method is being actively encouraged. However, by-products of logging, processing and conversion of wood are classified as difficult to burn fuels due to their high moisture content, low energy density and extremely heterogeneous granulometric composition. A promising direction to increase the energy density and transportability of the timber industry by-products is their granulation. Wood pellet fuel burning in heat-generating plants results in significant increase in their energy and environmental performance. The purpose of the paper is an experimental and calculation study of the energy and environmental performance of 4 MW hot water boilers produced by Polytechnik Luft- und Feuerungstechnik GmbH in the process of burning pine and spruce wood pellets obtained from by-products woodworking. When performing studies, the components of the boiler’s heat balance, gas release, and particulate emissions were determined. Numerical modeling of thermochemical and aerodynamic processes taking place in the boiler combustion chamber was carried out by using the Ansys Fluent three-dimensional simulation software. Together with industrial-operational tests it showed the possibility to reduce the total share of flue gas recirculation into combustion chambers of boiler units to values not exceeding 0.45, in providing an acceptable temperature of combustion products at the combustion chamber outlet and maintaining minimum emissions of carbon and nitrogen monoxides. At the same time, the share of gases fed by recirculation smoke exhausters to the over-bed area of the burner should have higher values than under the reciprocating grates of boilers. Guidelines for comprehensive improvement of wood pellet combustion efficiency in combustion chamber of 4 MW hot water boilers have been developed and implemented. The priorities are: using the air passed through the cooling channels of the setting as secondary air; reducing the rarefaction in the combustion chambers to 30–70 Pa; optimizing the ratio of primary and secondary air, herewith, the share of primary air in the total flow should be 0.26–0.35. Implementation of the developed guidelines allowed to increase the boiler gross efficiency by 0.5–1.8 %, to reduce the aerodynamic resistance of the gas path by 15–20 % and to ensure consistently low emissions of carbon and nitrogen monoxides and soot particles. When designing boiler units for burning wood pellet fuel it is advisable to place heating surfaces in the combustion chamber, included in the circulation circuit of the boiler. This will increase the efficiency and life cycle of the boiler unit.

Authors

Victor K. Lyubov¹, Doctor of Engineering, Prof.; ResearcherID: AAF-8949-2019,
ORCID: https://orcid.org/0000-0001-7050-1212
Aleksandr M. Vladimirov², Engineer; ResearcherID: AAB-8889-2021,
ORCID: https://orcid.org/0000-0003-0469-1104

Affiliation

¹Northern (Arctic) Federal University named after M.V. Lomonosov, Naberezhnaya Severnoy Dviny, 17, Arkhangelsk, 163002, Russian Federation; e-mail: vk.lubov@mail.ru
²Arkhangelsk Pulp and Paper Mill, ul. Mel’nikova, 1, Novodvinsk, Arkhangelsk region, 164900, Russian Federation; e-mail: vladimirovaleksandr23@gmail.com

Keywords

boiler, wood pellet fuel, harmful substances, numerical modeling, heat losses, efficiency

For citation

Lyubov V.K., Vladimirov A.M. Complex Efficiency of Using Wood Pellets in Power Plants. Lesnoy Zhurnal [Russian Forestry Journal], 2021, no. 1, pp. 159–172. DOI: 10.37482/0536-1036-2021-1-159-172

References

1. Bashmakov I.А., Myshak A.D. Costs and Benefits of the Transition to Low-Carbon Economy in Russia: Perspectives up to 2050. Voprosy Ekonomiki, 2014, no. 8, pp. 70–91. DOI: 10.32609/0042-8736-2014-8-70-91
2. Kokorin A. New Factors and Stages of the Global and Russian Climate Policy. Ekonomicheskaya Politika, 2016, vol. 11, no. 1, pp. 157–176. DOI: 10.18288/1994-5124-2016-1-10
3. Lyubov V.K., Lyubova S.V. Efficiency Improvement of the Biofuels Energy Use. Arkhangelsk, NArFU Publ., 2017. 533 p.
4. Lyubov V.K., Malygin P.V., Popov A.N., Popova E.I. Biofuel Combustion Efficiency of the Hot-Water Boiler. Biotechnology in the Chemical and Forest Complex: Proceedings of the International Scientific Conference, Arkhangelsk, September 11–12, 2014. Arkhangelsk, NArFu Publ., 2014, pp. 201–205.
5. Lyubov V.K., Malygin P.V., Popov A.N., Popova E.I. Determining Heat Loss into the Environment Based on Comprehensive Investigation of Boiler Performance Characteristics. Teploenergetika [Thermal Engineering], 2015, no. 8, pp. 36–41. DOI: 10.1134/S004060151506004X
6. Makarov I.A., Chen H., Paltsev S.V. Impacts of Paris Agreement on Russian Economy. Voprosy Ekonomiki, 2018, no. 4, pp. 76–94. DOI: 10.32609/0042-8736-2018-4-76-94
7. Measurement Procedure of the Mass Concentration of Soot in Industrial Emissions and in the Air of the Working Area. OAO Scientific Research Institute “TEKhUGLEROD”, 2005. 10 p.
8. Mokhirev A.P., Bezrukikh J.A., Medvedev S.O. Recycling of Wood Wastes of Timber Industry, as a Factor of Sustainable Resource Management. Inzhenernyy vestnik Dona [Engineering Journal of Don], 2015, no. 2, part 2, art. 81.
9. Popova E.I., Popov A.N., Lyubov V.K., Varakin E.A. Solid Fuels Combustion in the Hot Water Boiler Firematic 60. Proceedings of the 1st International Scientific and Practical Conference “Nature Management in the Arctic: Current State and Development Potential”, Yakutsk, September 22–25, 2015. Yakutsk, NEFU Publ., 2015, pp. 464–473.
10. Safonov G.V., Stetsenko A.V., Dorina A.L., Avaliani S.L., Safonova Yu.L., Besedovskaya D.S. The Strategy of Low-Carbon Development of Russia. Opportunities and Benefits of Substitution of Fossil Fuels with Green Energy Sources. Moscow, TEIS Publ., 2016. 48 p.
11. Collection of Methods for Determining the Concentrations of Pollutants in Industrial Emissions. Leningrad, Gidrometeoizdat Publ., 1987. 270 p.
12. Thermal Calculation of Boilers (Standard Method). Saint Petersburg, OAO Unified Energy System of Russia, 1998. 257 p.
13. TremISSN 0536-1036 «Известия вузов. Лесной журнал». 2021. № 1 171 bovlya V.I., Finger E.D., Avdeyeva A.A. Heating Tests of Boilers. Moscow, Energoatomizdat Publ., 1991. 416 p.
14. Arshadi M., Gref R., Geladi P., Dahlqvist S.-A., Lestander T. The Influence of Raw Material Characteristics on the Industrial Pelletizing Process and Pellet Quality. Fuel Processing Technology, 2008, vol. 89, iss. 12, pp. 1442–1447. DOI: 10.1016/j.fuproc.2008.07.001
15. Borchsenius H., Borgnes D. Black Carbon Emissions from the District Heating Sector in the Barents Region. NORSK ENERGI. Ministry of Environment of Norway. Project Name: RUS-11/0060. Norway, 2013. 56 p.
16. Flach B., Bendz K., Krautgartner R., Lieberz S. EU-27. Biofuels Annual Report No. NL3034. The Hague, USDA Foreign Agricultural Service, 2013. 34 p.
17. Gera D., Mathur M.P., Freeman M.C., Robinson A. Effect of Large Aspect Ratio of Biomass Particles on Carbon Burnout in a Utility Boiler. Energy & Fuels, 2002, vol. 16, iss. 6, pp. 1523–1532. DOI: 10.1021/ef0200931
18. Kruggel-Emden H., Wirtz S., Scherer V. An Experimental Investigation of Mixing of Wood Pellets on a Forward Acting Grate in Discontinuous Operation. Powder Technology, 2013, vol. 233, pp. 261–277. DOI: 10.1016/j.powtec.2012.08.029
19. Kurz D., Schnell U., Scheffknecht G. CFD Simulation of Wood Chip Combustion on a Grate Using an Euler-Euler Approach. Combustion Theory and Modelling, 2012, vol. 16, iss. 2, pp. 251–273. DOI: 10.1080/13647830.2011.610903
20. Magdziarz A., Wilk M., Straka R. Combustion Process of Torrefied Wood Biomass. Journal of Thermal Analysis and Calorimetry, 2017, vol. 127, pp. 1339–1349. DOI: 10.1007/s10973-016-5731-0
21. Petzold A., Ogren J.A., Fiebig M., Laj P., Li S.-M., Baltensperger U., Holzer-Popp T., Kinne S., Pappalardo G., Sugimoto N., Wehrli C., Wiedensohler A., Zhang X.-Y. Recommendations for Reporting “Black Carbon” Measurements. Atmospheric Chemistry and Physics, 2013, vol. 13, iss. 16, pp. 8365–8379. DOI: 10.5194/acp-13-8365-2013
22. Poletto M., Zattera A.J., Forte M.M.C., Santana R.M.C. Thermal Decomposition of Wood: Influence of Wood Components and Cellulose Crystallite Size. Bioresource Technology, 2012, vol. 109, pp. 148–153. DOI: 10.1016/j.biortech.2011.11.122
23. Porfiriev B.N., Roginko S.A. Energy on Renewable Sources: Prospects for the World and for Russia. Herald of the Russian Academy of Sciences, 2016, vol. 86, iss. 6, pp. 433–440. DOI: 10.1134/S101933161606006X
24. Scharler R., Obernberger I. Numerical Modelling of Biomass Grate Furnaces. Industrial Furnaces and Boilers: Proceedings of the 5th European Conference, April 11–14, 2000, Porto, Portugal. Porto, 2000. 17 p.
25. Simsek E., Brosch B., Wirtz S., Scherer V., Krüll F. Numerical Simulation of Grate Firing Systems Using a Coupled CFD/Discrete Element Method (DEM). Powder Technology, 2009, vol. 193, iss. 3, pp. 266–273. DOI: 10.1016/j.powtec.2009.03.011