Address: 17 Naberezhnaya Severnoy Dviny, Arkhangelsk 163002 Russian Federation. Northern (Arctic) Federal University named after M.V.Lomonosov. Office 1425

Phone / Fax: (818-2) 21-61-18
E-mail: forest@narfu.ru
http://lesnoizhurnal.ru/en/

RussianEnglish



Archive

On the Possibility of Using Dying Spruce for Production of High Yield Bisulphite Pulp

Версия для печати
Creative Commons License
These works are licensed under a Creative Commons Attribution 4.0 International License.

Yu.V. Sevastyanova,N.N. Fetyukova

Complete text of the article:

Download article (pdf, 0.5MB )

UDС

676.032

DOI:

Abstract

dead spruce will allow us to make a more objective assessment of the possible use of defective wood from mature and overmature spruce forests of the European North in the pulp and paper industry. At present, the volume of damaged wood is estimated at 150 million m3. As raw materials for the experiment we used industrial chips of dying, dead and normal spruce. Pulp samples were cooked in the laboratory. Grinding and refining of pulp were carried out in the centrifugal grinding machine in the laboratory. Semi-products were obtained and their quality was evaluated by standard methods. Geometrical dimensions of fiber were determined using the FiberTester analyzer. Deformation behavior and a number of strength properties were determined by the techniques developed in NArFU. The chemical analysis of dying, dead and normal wood samples indicates that dying wood has significant changes only in the content of extractives. Lignin content is higher in the upper part of healthy wood, while in the butt its content is almost unchanged. The content of easily hydrolyzed polysaccharides in normal wood is 3 % higher in the top part of the trunk and 4 % higher in the butt, as compared to dying and dead spruce. The maximum content of hard-to-hydrolyze polysaccharides was found in dying wood, increasing in the direction of the butt.The pulp yield from normal wood differed significantly from that of defective wood. Whereas the difference between the yields from normal and dying wood is about 10 % along the full length of the trunk, the difference between the yields from normal and dead wood is 12 %. The Kappa number of the pulp samples varies slightly. From the data obtained it may be concluded that the use of dead and dying spruce wood to produce bisulphite pulp is less cost effective due to the substantial difference in the yield of semi-finished products.

Authors

Yu.V. Sevastyanova, Candidate of Engineering, Associate Professor ;N.N. Fetyukova, Postgraduate Student ;I.M. Nevzorova, Postgraduate Student

Northern (Arctic) Federal University named after M.V. Lomonosov
Naberezhnaya Severnoy Dviny, 17, 163002, Arkhangelsk, Russia
E-mail: y-sevastyanova@yandex.ru

Affiliation

Northern (Arctic) Federal University named after M.V. Lomonosov

Keywords

dead spruce, high yield bisulphite pulp, structural-dimensional characteristics of fiber, standard strength characteristics of high yield pulp.

References

1. Voronin V.V. Usykhayushchie el'niki Arkhangel'skoy oblasti, problemy i puti ikh resheniya: sb. st. [Dying Spruce Forests of the Arkhangelsk Region, Problems and Solutions: Collected Papers]. Arkhangelsk, 2007. 2. Fedorov I.A. Usykhaet 10 % protsentov lesov Arkhangel'skoy oblasti! [10 % of Arkhangelsk Region Forests Are Dying!]. LesPromInform, 2005, no. 8 (30), pp. 42–44. 3. Matyushkina A.P., Ageeva M.I. Svoystva drevesiny i tsellyulozy iz sukhostoya sosny [Properties of Wood and Pulp from Pine Deadwood]. Fiziko-khimicheskie issledovaniya drevesiny i ee kompleksnoe ispol'zovanie [Physico-Chemical Studies of Wood and Its Multipurpose Use]. Petrozavodsk, 1978, pp. 24–36. 4. Korotaev G.E., Sevast'yanova Yu.V., Fetyukova N.N. Issledovanie strukturno-razmernykh i fundamental'nykh svoystv sul'fatnoy nebelenoy tsellyulozy, poluchennoy iz normal'noy, usykhayushchey i sukhostoynoy drevesiny eli [Study оf the Structure-Dimensional аnd Fundamental Properties оf Unbleached Sulphate Pulp Obtained from Normal, Dying and Dead Spruce]. Lesnoy zhurnal, 2013, no. 1, pp. 146–151. 5. Obolenskaya A.V., El'nitskaya Z.P., Leonovich A.A. Laboratornye raboty po khimii drevesiny i tsellyulozy [Laboratory Works on Wood and Cellulose Chemistry]. Moscow, 1991. 320 p.

On the Possibility of Using Dying Spruce for Production of High Yield Bisulphite Pulp

 

Make a Submission


ADP_cert_2024.png

Lesnoy Zhurnal (Russian Forestry Journal) was awarded the "Seal of Recognition for Active Data Provider of the Year 2024"

INDEXED IN: 


DOAJ_logo-colour.png

logotype.png

Логотип.png